Telnet connection with RT-LAB

This article explains how to do a telnet connection between the Windows Station and the RT-LAB QNX target:

1. Press Start windows button and go to the run command.

In the command port, type the command telnet xxx.xxx.xxx.xxx (where xxx.xxx.xxx.xxx represents the IP adress ex: 192.168.0.130)

2: A command prompt will pop-up:

Login: root

Password:

(there is no password)

 NOTE:  Windows 7 does not have Telnet enabled by default.  You can enable Telnet by following these steps:

1. Start
2. Control Panel
3. Programs
4. Turn Windows features on or off
5. Check Telnet Client / Telnet Server
6. Hit OK

After that you can start Telnet via Command Prompt or Run.

3. In the case you do not have the right to open a telnet session this way, we recommand you to use:

putty.exe that you will find at this adress:

http://www.chiark.greenend.org.uk/~sgtatham/putty/

Please see the usual configuration to set a telnet session with putty.